Filter
Top Products
Page 286 of 894 NT5D33 and NT5D34 Lineside E1 Interface cards
553-3001-211 Standard 2.00 September 2004
unable to accept new calls. Set this value to N if this state is not needed. If this
value is not set to N, then dip switch #2 position 6 will determine whether
off-hook or on-hook is sent to the M1/SL100 when this state is entered. See
Table 94 on page 258.
Figure 48
Set Mode (S M): Table screen
LEI:>S M
1) Default
2) Table
Hit <CR> to accept current value or type in a new one.
Current Mode : 1 New Mode : 2
Signaling Bits set to Table.
Incoming and outgoing calls are in reference to the CPE.
A
ll ABCD bits are with respect to SENDing from LEI/M1 to CPE
or RECEIVing from CPE to LEI/M1.
Please enter new ABCD bits or hit <CR> to accept. You may
enter 2 or 4 values. If only 2 values are entered, the A and
B bits will be copied to the C and D bits.
IDLE SEND: Current: 0000 New: 0101
IDLE SEND bits changed to: 0101
IDLE RECEIVE: Current: 0101 New:
IDLE RECEIVE bits unchanged.
BLOCKING RECEIVE enabled? (Y/N): N
BLOCKING RECEIVE is disabled.
Incoming call RINGER-ON SEND: Current: 0000 New:
Incoming call RINGER-ON SEND bits not changed.
Incoming call RINGER-OFF SEND: Current: 0101 New: 0101
Incoming call RINGER-OFF SEND bits not changed.
Incoming call OFFHOOK RECEIVE: Current: 1111 New: 11
Incoming call OFFHOOK RECEIVE bits not changed.
Incoming call CONNECTED SEND: Current: 0101 New:
Incoming call CONNECTED SEND bits not changed.
Incoming call (Far End) DISCONNECT SEND: Current: 1111 New:
Incoming call (Far End) DISCONNECT SEND bits not changed.
Incoming call (CPE) DISCONNECT RECEIVE: Current: 0101 New:
Incoming call (CPE) DISCONNECT RECEIVE not changed.