Filter
Top Products
NT5D33 and NT5D34 Lineside E1 Interface cards Page 285 of 894
Circuit Card Description and Installation
Idle SEND – This is the value that the LEI sends (acting as the CO or PSTN)
when the circuit is in the idle state. This value is required.
Idle RECEIVE – This is the value that the LEI expects to see from the CPE
when it is in the idle state. This value is required.
Blocking RECEIVE – This is the value that the LEI expects to see from the
CPE when the customer equipment is in the blocking or fault state and is
Figure 47
Set Mode (S M): Table screen
Outgoing call SEIZE RECEIVE: Current: 0001 New: 111
Error: Note enough values specified. Enter either 2 or 4
values.
Outgoing call SEIZE RECEIVE: Current: 0001 New: 11
Outgoing call SEIZE RECEIVE bits changed to: 1111
Outgoing call SEIZE ACK SEND enabled? (Y/N): N
Outgoing call SEIZE ACK SEND is disabled.
Outgoing call DIAL MAKE RECEIVE: Current: 1111 New:
Outgoing call DIAL MAKE RECEIVE bits not changed.
Outgoing call DIAL BREAK RECEIVE: Current: 1010 New:
Outgoing call DIAL BREAK RECEIVE bits not changed.
Outgoing call ANSWERED SEND: Current: 0101 New:
Outgoing call ANSWERED SEND bits not changed.
Outgoing call (CPE) DISCONNECT RECEIVE: Current: 0101 New:
Outgoing call (CPE) DISCONNECT RECEIVE bits not changed.
Outgoing call (Far End) DISCONNECT SEND: Current: 1111 New:
Outgoing call (Far End) DISCONNECT SEND bits not changed.
Disconnect Time (0 to 4000 ms): 1000
Disconnect Time not changed.
Intercall Time (0 to 2000 ms): 800
Intercall Time not changed.
LEI:>