Filter
Top Products
Page 276 of 894 NT5D33 and NT5D34 Lineside E1 Interface cards
553-3001-211 Standard 2.00 September 2004
Each of these commands can be executed by entering the first letter of the
command or by entering the entire command. Commands with more than one
word are entered by entering the first letter of the first word, a space, and the
first letter of the second word or by entering the entire command. Table 100
shows all possible MMI commands in alphabetical order. These commands
are also described later in this section.
Table 100
MMI commands and command sets (Part 1 of 2)
Command Description
A D Alarm Disable. Disables all alarms.
A E Alarm Enable. Enables all alarms.
C A Clear Alarm. Clears all alarms, terminates time processing, and resets
the E1 bit error rate and frame slip counters.
C A L Clear Alarm Log. Clears alarm log.
C E Clear Error. Clears the E1 error counter.
D A(P) Display Alarms. Displays the alarm log, which is a list of the 100 most
recent alarms with time and date stamps. (Momentarily stop the
scrolling display by typing P. Continue scrolling by typing any other
key.)
D C(P) Display Configuration. Displays the configuration settings for the
LEI(s), single- or multiple-card system. Display includes each card’s
serial number, MMI firmware version, date and time, alarm
disable/enable setting, self-clearing disable/enable setting, values
entered through the Set Configuration command, and dip switch
settings.(Momentarily stop the scrolling display by typing P. Continue
scrolling by typing any other key.)
D H(P) Display History. Displays performance counters for the past 24 hours.
(Momentarily stop the scrolling display by typing P. Continue scrolling
by typing any other key.)
D P Display Performance. Displays performance counters for the current
hour.