Page 216 of 894 NT5D11 and NT5D14 Lineside T1 Interface cards
553-3001-211 Standard 2.00 September 2004
The MMI then prompts for a password. The password is “LTILINK”, and it
must be typed all in capital letters.
After logging in, the prompt will then look like this:
• LTI:::> for single-card installations
• LTI:ss cc> for multi-card installations, where ss represents the two-digit
address, and cc represents the two-digit card slot address
Basic commands
MMI commands can now be executed. There are seven basic commands that
can be combined together to form a total of 19 command sets. They are:
•Alarm
• Clear
•Display
•Set
•Test
•Help
• Quit
If ?<CR> is typed, the MMI will list the above commands along with an
explanation of their usage A screen similar to the following will appear. The
help screen can also appear by typing H<CR>, or HELP<CR>.
ALARM USAGE: Alarm [Enable | Disable]
CLEAR USAGE: Clear [Alarm] | [Error counter] [Log]
DISPLAY USAGE: Display [Alarm | Status | Perform |
History] [Pause]
HELP USAGE: Help | ?
SET USAGE: Set [Time | Date | Alarm | Clearing |
Name | Memory]
TEST USAGE: Test [Carrier All]
QUIT USAGE: Quit