Page 480 of 894 NT7D16 Data Access card
553-3001-211 Standard 2.00 September 2004
You can view any of the S registers by issuing the following display
command. Any S register can be specified through the ATS command, and
the system will display the current setting for that parameter. More than one
S register can be viewed by listing the desired registers on the same command
line.
One register Two registers
ATS8? ATS8? S9
20 002
OK 006
OK
To change any S register range, except S1, use the following change
command. The new parameters remain in effect until another change
command is given or the Hayes Reset modem command (Z) is issued. If the
DAC is powered up, the parameters are reset to the defaults.
ATS8 = 15
OK
S8 0–30 Seconds Ye s Duration for the dial pause
character
S9 1–255 0.1 second No Carrier detect response time
S10 1–255 0.1 second No Delay time between loss of carrier
and call release
S11 50–255 Milliseconds No Touch tone spacing
S12 20–255 20 milliseconds Ye s Guard time for the escape
sequence
Table 156
Allowable S registers (Part 2 of 2)
S register Range Range units Supported Description