NT7D16 Data Access card Page 509 of 894
Circuit Card Description and Installation
Printing the card parameters (LD 20)
By responding R232, R422, or DAC to the TYPE prompt in LD 20, you can
print out the configured parameters for each port, or the entire DAC. This is
useful to determine if any parameters have been altered during keyboard or
Hayes dialing modify procedures.
The operation parameter printout for an RS-232 or RS-422 port is similar to
the following, depending on the configuration.
LD 20 – Print DAC parameters.
Prompt Response Description
REQ: PRT
LTN
LUU
Print data, TN, or unit information for the unit specified
TYPE: R232
R422
DAC
Print information for the RS-232-C, RS-422 ports, or the
whole DAC
TN l s c u Print information for this TN, where l = loop, s = shelf,
c = card, u = unit. Uploaded parameters can only be
printed when a specific TN is listed.
Table 167
Print out example (Part 1 of 2)
DBASE
R-232 or R-422
UPLOAD
R-232 or R-422
PAR SPAC SPAC
DTR ON ON
HOT OFF OFF
AUT ON O
Note: The Upload parameters are printed only when a single TN is
specified.