Filter
Top Products
Page 288 of 894 NT5D33 and NT5D34 Lineside E1 Interface cards
553-3001-211 Standard 2.00 September 2004
Outgoing call DIAL BREAK RECEIVE – This is the value that the LEI
expects to see from the CPE during the break part of the digit. This value is
required.
Outgoing call ANSWERED SEND – This is the value that the LEI will
send to indicate that the far-end has answered the call. This value is required.
Outgoing call (CPE) DISCONNECT RECEIVE – This is the value that
the LEI expects to see from the CPE when the customer equipment wishes to
end the call. This value is required.
Outgoing call (Far-end) DISCONNECT SEND – This is the value that
the LEI will send to indicate that the far-end has released the call This value
is required.
Disconnect Time – This is the number of milliseconds that the LEI will
send the disconnect signal to the CPE before reverting to the idle state. If the
CPE reverts to a connected state during this time, it is ignored. This value is
only used when disconnect supervision is available and is needed for the
signaling type in use. It is used when the far-end initiates the disconnect. For
loop start cases, this value is not used.
Intercall (release guard) Time – This is the number of milliseconds that
the LEI maintains the idle signal to the CPE before initiating a new call. The
CPE should not initiate a new call during this time. If it does so, the off-hook
indication is ignored until the release guard time has expired. This value
defaults to 0 which relies on the M-1 to observe the proper guard time. If a
non-zero value is entered, off-hook from the CPE and Ringer-On commands
from the M1/SL100 is ignored until this timer has expired.
Display Configuration (D C)
The Display Configuration (D C) command displays the various
configuration settings established for the LEI. Entering this command causes
a screen similar to Figure 49 to appear.