Filter
Top Products
5 - 7
5 START-UP PROCEDURES
5.3 Operating System Software Installation Procedure
The operating system software must be installed to the Motion controller by using the
peripheral device and MT Developer2.
The installation procedure is shown below.
Start the install of MT Developer2.
Set the connection method between
the personal computer and Motion
controller in the Transfer Setup.
Select the operating system software
installed, and install it in the Motion
controller.
Dialog "Installation is completed" is
displayed.
The operating system software can be
installed normally by dialog display.
Operation in
MT Developer2
(Note)
START
Set a rotary switch1 (SW1) of Motion
controller to "A".
(Rotary switch 2 (SW2) is optional.)
Factory default in SW1 "A",
SW2 "0" position.
Turn ON the Motion controller's power
supply.
Set to installation mode.
Refer to Section 2.5.1(6) for rotary switch.
Steady "INS" display.
RUN/STOP is ignored.
Turn OFF the Motion controller's
power supply.
Set a rotary switch1 (SW1) and
switch2 (SW2) of Motion controller to
"0".
Set to mode operated by RAM.
END
(Note): Install the operating system software by screen of MT Developer2.
Refer to help of MT Developer2 for details.