Filter
Top Products
D9412GV3/D7412GV3 | Program Entry Guide | 2.0 Panel and Area Wide Parameters EN | 73
Bosch Security Systems, Inc. | 10/11 | F01U170807-02
L## Bypass a Point
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
25 Bypass a Point [COMMAND][0]
Bypass points with this authority level.
L## Unbypass a Point
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
26 Unbypass a Point [COMMAND][0][0]
Unbypass points with this authority level.
L## Reset Sensors
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
27 Reset Sensors [COMMAND][4][7]
Reset sensors with this authority level.
L## Change Relay
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
28 Change Relays [COMMAND][5][4]
Manually activate or reset a system relay.
Do not use the Change Relays function
to toggle relays reserved for special
functions. Special function relays are
Area and Panel Wide Relay functions as
well as relays assigned to CC# Enter
Key Relay?
L## Remote Program
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
29
Remote
Programming
[COMMAND][4][3]
Start a remote programming software (RPS) session
when the phone rings at the control panel.
L## Move to Area
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
30 Move to Area [COMMAND][5][0]
Temporarily switch to a different area and perform
keypad functions related to that area.
L## Display Rev
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
32
Display Software
Revision
[COMMAND][5][9]
Display the control panel model name and software
revision. For example:
9412GV3 REV ##.##
L## Service Walk
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
33
Service Walk
Test
(Menu function
only)
Start a Service Walk Test for all 24-hour Interior or
Perimeter Controlled points in the control panel.
Points are not included in this test if:
Points are in an area that is already in a Walk
Test Mode.
Points are assigned to an area that is not
enabled A# Area On.
Points are in an area that is Master or Perimeter
armed.
When a Service Walk Test is initiated, one person
can test all the points in the control panel without
assistance. The following features are provided with
the Service Test Mode:
Display indicates exactly how many points can be
tested.
Battery and bell tests do not occur during this
Walk Test.
The test ends when all points are tested or the
test times out after 20 min of inactivity.