Filter
Top Products
D9412GV3/D7412GV3 | Program Entry Guide | 2.0 Panel and Area Wide Parameters EN | 56
Bosch Security Systems, Inc. | 10/11 | F01U170807-02
CC# Scroll Lock
Default: No
Selection:
Yes or No
Yes Prevents the idle system status text
from scrolling automatically.
Requires user intervention to
advance.
No Allows the idle system status text to
scroll automatically without user
intervention
Use this parameter to enable a special non-scrolling
option for the idle system status display text on a
keypad. This keypad mode requires the user to press
the PREV or NEXT key on the keypad to unlock the
display and begin scrolling through the system status
displays.
CC# Menu Key Lock
Default: No
Selection:
Yes or No
Yes If set to Yes, the user is prompted to
enter a passcode after pressing the
Menu key on the keypad. The items
programmed in the Menu List for this
specific keypad are filtered by the
user’s authority level. Only those
items in the menu list for which the
user has authority appear.
No If set to No, when the user presses
the Menu key, all items that are
programmed in the Menu List for the
Command Center Address (Keypad
Address) appear, regardless of the
user’s authority level.
Determines if the Menu Key, when pressed, requires
a passcode to access the functions.
If this parameter is set to Yes, users must
enter a passcode after pressing the Menu
key. When the passcode is validated,
only those functions for which the user
has authority appear in the list. If a
function in the Menu List is passcode
protected (refer to Keypad Functions in
Section 2.11.2 User Interface on page)
the user does not need to enter the
passcode again.
CC# Abort Display
Default: Yes
Selection:
Yes or No
Yes This keypad shows the Alarm
Aborted message for all aborted
alarms within its scope.
No This keypad does not show the
Alarm Aborted message for all
aborted alarms within its scope.
This parameter enables or disables the ALARM NOT
SENT message when an alarm is aborted before
transmission occurs.
For SIA CP-01 Compliance
CC# Abort Display can be set to Yes or No.
CC# Cancel Display
Default: Yes
Selection:
Yes or No
Yes This keypad shows the Cancel
Report Sent message for all canceled
alarms within its scope.
No This keypad does not show the
Cancel Report Sent message for all
canceled alarms within its scope.
This parameter enables or disables the CANCEL
REPORT SENT display message when an alarm is
canceled after transmission occurs. To show this
message, Cancel Report must be set to Yes. Refer to
Cancel Report on page 36.
For SIA CP-01 Compliance
CC# Cancel Display can be set to Yes or No.
2.9.2 Area Text
Use this programming category to create custom Idle
Text displays for the keypads.
Each display can be programmed with up
to sixteen alphanumeric characters,
including: A to Z, 0 to 9, ?, &, @, -, *,
+, $, #, _, /.
Characters not listed are invalid and
cannot be used for text.