Filter
Top Products
D9412GV3/D7412GV3 | Program Entry Guide | 6.0 ACCESS CONTROL EN | 140
Bosch Security Systems, Inc. | 10/11 | F01U170807-02
Table 38: Cross Point Ranges Within Groups
Cross Point
Group Point Range
1 1 to 8
2 9 to 16
3 17 to 24
4 25 to 32
5 33 to 40
6 41 to 48
7 49 to 56
8 57 to 64
9 65 to 72
10 73 to 80
11 81 to 88
12 89 to 96
13 97 to 104
14 105 to 112
15 113 to 120
16 121 to 127
17 129 to 136
18 137 to 144
19 145 to 152
20 153 to 160
21 161 to 168
22 169 to 176
23 177 to 184
24 185 to 192
25 193 to 200
26 201 to 208
27 209 to 216
28 217 to 224
29 225 to 232
30 233 to 240
31 241 to 247
Refer to Section 2.3 Routing on page 17 for
information about programming the destination (for
example, the central station) for Unverified Events.
An Unverified Event does not produce a
corresponding Restoral Event.
The Cross Point function applies only to alarm
conditions. It does not apply to supervisory or trouble
conditions. Points programmed with point response D
(Delayed) eventually enter into an alarm condition if
the area is not disarmed in time.
Cross Point Time
Default: 20 sec
Selection: 5 sec to 255 sec
Select the amount of time (in seconds) that points
within a Cross Point Group are in alarm before a
Cross Point event is generated.
6.0 ACCESS CONTROL
6.1 Door Profile
This programming category is used to:
Assign an area that also activates the D9210B
Assign a point to the door
Program the door state to change the time when
the arm state changes
Allow for the Strike relay to activate upon a fire
alarm
Programming the Interlock point.
Door #
Default: 1
Selection: 1 to 8
Enter the number of the door you are programming.
The D9412GV3 supports up to eight
doors. The D7412GV3 supports two
doors.
D# Entry Area #
Default: 0
Selection: 0 to 8
1 to 8
The area assigned to the door
controller to which the reader allows
access.
0 Door controller does not function.
Assign an area to the door controller. This entry
allows the D9210B to be polled, activating
communication to the control panel. This is also the
area a user exits when initiating an REX.
The D# Entry Area # prompt for the
D9412GV3 is limited to the first 8 areas.