Filter
Top Products
D9412GV3/D7412GV3 | Program Entry Guide | 1.0 Introduction EN | 6
Bosch Security Systems, Inc. | 10/11 | F01U170807-02
1.2 Guide to Programming Options
Full configuration of the control panel is only achieved through use of the Remote Programming Software
(RPS). A limited keypad programmer’s mode is available to modify some of the more commonly changed
parameters.
This guide is set up in a specific order. Related program entries are grouped together in modules as they
appear in RPS.
This guide shows the programming options for each programming prompt. Each option is listed with:
The Program Item Prompt: Each prompt is shown as it appears in RPS. Refer to the RPS Installation
Guide (P/N: 4998141259).
Program Entry Default Setting: Because defaults are set for the typical installation, programming each
prompt might not be necessary. Review the default entries in the program record sheet shipped with the
control panel to determine which prompts must be programmed.
Program Entry Selections: Only the selections listed can be used for a particular program item.
Program Entry Description: Describes the various entry selections. Read the descriptions carefully to
avoid improperly programmed equipment.