Filter
Top Products
D9412GV3/D7412GV3 | Program Entry Guide | 2.0 Panel and Area Wide Parameters EN | 35
Bosch Security Systems, Inc. | 10/11 | F01U170807-02
RPS Phone #
Default: Blank
Selection:
Blank or up to 24 characters
Blank Control panel does not dial a phone
number for RPS.
1 to 24
characters
Enter up to 24 characters to define
dialing characteristics.
This is the phone number the control panel dials to
contact RPS. Refer to Section 2.6.1 on page 32 for
instructions on configuring special phone number
digits to detect dial-tone detect and to pause dialing.
The control panel dials this number when any of the
following events occur:
Log % Full threshold is achieved.
If Log % Full is programmed with a
value (1 to 99) and an RPS phone
number or RPS IP address are
programmed, the control panel attempts
to communicate with Unattended RPS
when the log threshold is reached.
The control panel is contacted by RPS and RPS
Call Back is programmed Yes.
The user enters COMMAND 43 and selects the
call RPS option from the menu. On the D1255:
1. Press [COMAND][4][3].
2. Press [NEXT] until RPS via Phone? appears,
then press [ENTER].
The control panel tries to contact RPS
only once using this method.
Refer to Section 5.4 SDI RPS Parameters on page
126 for other connection methods.
Refer to Phone # in Section 2.1 Phone
on page 12 for descriptions of special
programming values for the RPS Phone
number.
Keypad Programming of RPS PHONE #
D1255
1. Refer to Figure 1 on page 7 to access Keypad
Programming and navigate to the RPS
PARAMETERS option. Press [ENT]. The keypad
shows the RPS PASSCODE option and the
currently configured passcode.
2. Press [NEXT] to advance to the RPS PHONE
NUMBER option.
3. The keypad shows the currently configured phone
number. Press [ENT] to edit the phone number.
4. The [PREV] button acts as a [Backspace] key.
Press [PREV] to delete the characters of the
phone number, and then enter the new phone
number.
5. Press [ENT] to save the phone number.
When the keypad reads PARAMETER SAVED,
your selection has been configured.
D1260
1. Refer to Figure 2 on page 8 to access Keypad
Programming and navigate to the RPS
Parameters option. Press [ENTER]. The keypad
shows the RPS Passcode and the currently
configured passcode.
2. Press Phone Number softkey.
3. The keypad shows the currently configured phone
number.
4. Press the Edit softkey to change the phone
number.
5. The Pause and DT Detect (Dialtone Detect)
softkeys enter special characters. The Backspace
softkey allows you to erase characters. The Clear
softkey allows you to clear the entire phone
number. The [COMMAND] and [ENTER] keys
allow you to enter an * or a #. Use the softkeys,
the number buttons, and the [COMMAND] and
[ENTER] keys on the keypad to enter the new
phone number.
6. Press [ENT] to save the phone number.
When the keypad reads Parameter Saved, your
selection has been configured.
RPS Modem Speed
Default: 1200
Selection:
300, 1200, 2400
Select the baud rate for RPS-to-control panel
communication when using a PSTN connection.