Filter
Top Products
D9412GV3/D7412GV3 | Program Entry Guide | 5.0 AUXPARM EN | 133
Bosch Security Systems, Inc. | 10/11 | F01U170807-02
8. The keypad shows the currently configured IP
address. Press [NEXT]. The currently configured
port number shows.
9. Press [ENT] to change the port number.
10. The [PREV] button acts as a [Backspace] key.
Press [PREV] to delete the characters of the port
number and then enter the new port number.
11. Press [ENT] to save the changes.
When the keypad reads PARAMETER SAVED, your
selection is configured.
12. Press [NEXT]. The currently configured path poll
rate shows.
13. Press [ENT] to change the path poll rate.
14. The [PREV] button acts as a [Backspace] key.
Press [PREV] to delete the characters of the poll
rate then enter the new poll rate.
15. Press [ENT] to save the changes.
When the keypad reads PARAMETER SAVED, your
selection is configured.
D1260
1. Refer to Figure 2 on page 8 to access Keypad
Programming and navigate to the Enhanced
Comm option. Press [ENT].
2. The Enhanced Enabled configuration shows, as
does the Select IP Path option. Press the Select
IP Path to access the Path (1 – 4) prompt.
3. Enter the path number you wish to configure and
press [ENTER]. The currently configured IP
address shows.
4. Press the Select IP Path softkey to change the
IP address. An editing cursor is enabled for the
first byte.
5. The Previous and Next softkeys move the
cursor through the bytes. The Backspace
softkey allows you to erase characters. The
Clear softkey allows you to clear the entire IP
address. Use the softkeys and the number
buttons on the keypad to enter the new IP
address.
The keypad only accepts byte numbers
valid for the current prompt.
6. Press the Save softkey to save the changes.
When the keypad reads Parameter Saved, your
selection is configured.
7. The keypad shows the currently configured IP
address and the Port Number option. Press the
Port Number softkey. The currently configured
port number shows.
8. Press the Edit softkey to change the port
number.
9. The Backspace softkey allows you to erase
characters. The Clear softkey allows you to clear
the entire IP address. Use the softkeys and the
number buttons on the keypad to enter the new
port number.
10. Press the Save softkey to save the changes.
When the keypad reads Parameter Saved, your
selection is configured.
11. When the keypad shows the currently configured
port number and the Poll Rate option, press the
Poll Rate softkey. The currently configured path
poll rate shows.
12. Press the Edit softkey to change the path poll
rate.
13. The Backspace softkey allows you to erase
characters. The Clear softkey allows you to clear
the entire poll rate. Use the softkeys and the
number buttons on the keypad to enter the new
poll rate.
14. Press the Save softkey to save the changes.
When the keypad reads Parameter Saved, your
selection is configured.