Filter
Top Products
D9412GV3/D7412GV3 | Program Entry Guide | 5.0 AUXPARM EN | 126
Bosch Security Systems, Inc. | 10/11 | F01U170807-02
Status Rate
Default: 0
Selection: 0 to 255
0
Status information is sent only when
requested.
1 to 255
Status information is sent at the
interval programmed.
If the Status Rate is set to a value less
than 10, and 1 to 6 SDI devices are
connected to the system, the fastest the
control panel can send the status
information is in approximately 1 sec. If
more than six SDI devices are connected
to the control panel, the fastest the
control panel can send the information is
in approximately 1.5 sec to 2 sec.
This item determines how often the default status
information is sent to the serial interface module
(SIM). The status information includes:
The current point status (normal or off-normal),
The control panel’s area status (Master Armed,
Master Instant Armed, Perimeter Delay Armed,
Perimeter Instant Armed, Disarmed, Area Entry
Delay, Perimeter Entry Delay, Area Exit Delay,
and Perimeter Exit Delay)
The control panel status (AC Fail, Battery
Missing, AC Restore, Battery Low, and so on)
Relay status (relay on or relay off)
Entries are in 100 millisecond increments. If a 5 is
entered, the status information is sent every 500
milliseconds (or 0.5 sec). An entry of 10 equals 1 sec.
5.4 SDI RPS Parameters
Configure remote programming software (RPS)
parameters when communicating over a private local-
area network (LAN), wide-area network (WAN), or
general packet radio system (GPRS). To allow RPS
to communicate with a control panel over a LAN or
WAN, an SDI-Ethernet network interface module
(NIM) and RPS (version 5.13 or higher) are required.
The computer on which RPS is installed needs a
network card. See your information systems
administrator for network requirements.
This section allows you to:
Provide for local programming by a DX4010V2
Serial Interface Module.
Provide remote programming by a Conettix
DX4020 Network Interface Module or an
ITS-DX4020-G.
Provide enhanced route paths for event reporting
through a network using a Conettix DX4020
Network Interface Module or an ITS-DX4020-G.
Although not listed in this section, RPS checks for the
RPS passcode (refer to Section 2.6 RPS Parameters
on page 32), Datalock Code, and control panel type
to determine if this RPS session should continue.