Filter
Top Products
Polycom® RealPresence Collaboration ServerVirtual Edition Administrator’s Guide
20-32 Polycom, Inc.
TCP_RETRANSMISSION_TI
MEOUT
The number of seconds the server will wait for a TCP client to
answer a call before closing the connection.
Default = 5 (seconds)
V35_MULTIPLE_SERVICES If the connection of multiple Serial Gateways to RTM-LAN
cards is required:
The V35_MULTIPLE_SERVICES System Flag must be set to
YES.
The default value of the V35_MULTIPLE_SERVICES System
Flag is NO, enabling only one Serial Gateway to be supported
per RTM-LAN card.
V35_ULTRA_SECURED_SU
PPORT
This flag must be set to YES when deploying a Serial
Gateway S4GW in Ultra Secure Mode..
VSW_CIF_HP_THRESHOLD
_BITRATE
Controls the Minimum Threshold Line Rate (kbps) for CIF
resolution for High Profile-enabled VSW conferences.
Default: 64
VSW_HD1080p_HP_THRES
HOLD_BITRATE
Controls the Minimum Threshold Line Rate (kbps) for
HD1080p resolution for High Profile-enabled VSW
conferences.
Default: 1024
VSW_HD720p30_HP_THRE
SHOLD_BITRATE
Controls the Minimum Threshold Line Rate (kbps) for
HD720p30 resolution for High Profile-enabled VSW
conferences.
Default: 512
VSW_HD720p50-
60_HP_THRESHOLD_BITR
ATE
Controls the Minimum Threshold Line Rate (kbps) for
HD720p50 and HD720p50 resolutions for High Profile-
enabled VSW conferences.
Default: 832
VSW_RATE_TOLERANCE_
PERECENT
Determines the percentage of bandwidth that can be
deducted from the required bandwidth to allow participants to
connect to the conference.
For example, a value of 20 will allow a participant to connect
to the conference if the allocated line rate is up to 20% lower
than the conference line rate (or between 80% to 100% of the
required bandwidth).
Range: 0 - 75
Default: 0
VSW_SD_HP_THRESHOLD
_BITRATE
Controls the Minimum Threshold Line Rate (kbps) for SD
resolution for High Profile-enabled VSW conferences.
Default: 128
WRONG_NUMBER_DIAL_
RETRIES
The number of re-dial attempts for a wrong destination
number or a wrong destination number time-out.
Range: 0 - 5
Default: 3
A flag value of 0 means that no redials are attempted.
Table 20-2 Manually Added System Flags – MCMS_PARAMETERS (Continued)
Flag Description