Filter
Top Products
Chapter 20-System Configuration Flags
Polycom, Inc. 20-27
REMOVE_H323_EPC_CAP_
TO_NON_POLYCOM_VEND
OR
Used to disable EPC protocol. Use of Polycom’s proprietary
protocol, High Profile, EPC, may result in interoperability
issues when used with other vendors’ endpoints.
Possible values: YES / NO
Default: NO
REMOVE_H323_HIGH_PRO
FILE_CAP_TO_NON_POLY
COM_VENDOR
Used to disable High Profile protocol. Use of Polycom’s
proprietary protocol, High Profile, may result in interoperability
issues when used with other vendors’ endpoints.
Possible values: YES / NO
Default: NO
REMOVE_H323_HIGH_QUA
LITY_AUDIO_CAP_TO_NON
_POLYCOM_VENDOR
Used to disable the following Audio Codecs:
• G7221C
• G7221
• Siren22
• Siren14
Possible values: YES / NO
Default: NO
REMOVE_H323_LPR_CAP_
TO_NON_POLYCOM_VEND
OR
Used to disable H.323 LPR protocol. Use of Polycom’s
proprietary protocol, H.323 LPR, may result in interoperability
issues when used with other vendors’ endpoints.
Possible values: YES / NO
Default: NO
REMOVE_IP_IF_NUMBER_
EXISTS
Between the time a conference is scheduled and when it
becomes active, the IP of an endpoint may change, especially
in an environment that uses DHCP. This flag determines if the
E.164 number is to be substituted for the IP address in the
dial string.
Range: YES / NO
Default: YES - The IP address will be substituted with the
E.164 number.
RMX_MANAGEMENT_SEC
URITY_PROTOCOL
Enter the protocol to be used for secure communications.
Default: TLSV1_SSLV3 (both).
RTCP_FIR_ENABLE When set to YES, the Full Intra Request (FIR) is sent as INFO
(and not RTCP).
Default = YES
RTCP_FLOW_CONTROL_T
MMBR_ENABLE
Enables/disables the SIP RTCP flow control parameter.
Default: YES
RTCP_FLOW_CONTROL_T
MMBR_INTERVAL
Modifies the interval (in seconds) of the TMMBR (Temporary
Maximum Media Stream Bit Rate) parameter for SIP RTCP
flow control.
Range: 5 - 999 (seconds)
Default: 180
Table 20-2 Manually Added System Flags – MCMS_PARAMETERS (Continued)
Flag Description