Filter
Top Products
OUT C
- 56 -
{ OUT C ... Counter output
Usable device
Bit device
Word device
Con-
stant
Pointer Level
X Y M L SM F T C D R Z K H P N
Digit
desig-
nation
No. of
steps
Index
Device
Setting
value
3
C1 D10
C0 K50
Device No.(C0 to 127)
Setting value
(1 to 32767 is valid)
Setting value
(1 to 32767 is valid for
the data register details)
Device No.(C0 to 127)
Function
(1) If the operation results before the OUT command change from OFF to ON, the current value
(count value) will be incremented by one. When the value is counted up (current value >= setting
value), the contacts will change as shown below.
A contact Continuity
B contact Non-continuity
(2) The value will not be counted when the operation results are ON. (A pulse change is not required
to input the count.)
(3) If the operation results change from OFF to ON after the "current value >= setting value" is
established, the contact state will remain the same, however the current value will be
incremented by 1.
Execution condition
This is executed per scan regardless of the operation results before the OUT command.