Filter
Top Products
9. Exclusive Commands
- 237 -
(2) In manual mode
In the jog and step mode, when the chopping axis is not moving, the chopping operation is started
at the rising edge of the "Chopping" signal.
If the "Chopping" signal is turned ON when the chopping axis is moving, the OPERATION ALARM
0154 will occur, and the chopping will not be started.
(Rising edge of the "Chopping" signal is ignored.)
(a) When the chopping axis is not moving:
Chopping axis
(1)
(3)
(2)
In chopping start (X260)
In chopping mode (X265)
Chopping (Y1E8)
(b) When the chopping axis is moving:
Chopping axis
In chopping start (X260)
In chopping mode (X265)
Operation alarm 0154
Chopping (Y1E8)
In the handle mode, when the chopping axis is not selected as the handle axis, the chopping
operation is started at the rising edge of the "Chopping" signal.
If the "Chopping" signal is turned ON when the chopping axis is selected as the handle axis, the
OPERATION ALARM 0154 will occur, and the chopping is not started.