Filter
Top Products
11. PLC Axis Control
- 298 -
11.3.5 Handle Feed Axis Selection
The axis is designated for the following devices when handle feed is carried out with a PLC axis.
Device No. Signal name
Y2E0
Y2E1
Y2E2
Y2E3
Y2E4 PCH1 PLC axis 1st handle valid
Y2E5 PCH2 PLC axis 2nd handle valid
Y2E6
Y2E7
When Y2E4 and Y2E5 are ON, each handle changes to PLC axis dedication.
Y248 to Y24C, Y24F, Y250 to Y254 and Y257 usually used in the control device are
used for the axis selection of each handle.
PLC axes are counted as PLC such as first axis and second axis. Therefore, if you will
operate the first handle in the first axis of PLC, turn ON Y2E4, Y248 to Y24C and Y24F.
(Note) The handle feed magnification is also used for NC control axes.