Filter
Top Products
Introduction
These specifications are the programming manual used when creating the sequence
program for the EZMotion-NC E60/E68 with the onboard PLC development tool or PLC
development software.
The PLC (Programmable Logic Controller) is largely divided into the basic commands,
function commands and exclusive commands, and ample command types are available.
The commands can be used according to the purpose and application such as the PLC
support function used when supporting the user PLCs.
Details described in this manual
CAUTION
For items described in "Restrictions" or "Usable State", the instruction manual
issued by the machine maker takes precedence over this manual.
Items not described in this manual must be interpreted as "not possible".
This manual is written on the assumption that all option functions are added.
Refer to the specifications issued by the machine maker before starting use.
Refer to the Instruction Manual issued by each machine maker for details in each
machine tool.
Some screens and functions may differ or may not be usable depending on the
NC version.
General precautions
(1) This Instruction Manual does not explain the operation procedures for programming
the sequence program with onboard or personal computer. Refer to the related
material listed below for details.
EZMotion-NC E60/E68 PLC Onboard Instruction Manual ..... IB-1500179(ENG)
EZMotion-NC E60/E68 PLC Interface Manual ..... IB-1500176(ENG)
EZMotion-NC E60/E68 PLC Development Software Manual
(MELSEC Tool Section)
..... IB-1500177(ENG)