Filter
Top Products
5. Explanation of Devices
- 19 -
100ms integrated timer T
(a) When the input conditions are set, the count starts. When the set value is counted, that timer contact
will turn ON.
(b) Even the input conditions are turned OFF, the 100ms integrated timer current value (count value)
will be held, and the contact state will not change.
(c) The 100ms integrated timer count value will be set to 0 and the contact will turn OFF when the RST
command is executed.
T233 K100
X5
100ms cumulative timer
Input conditions
T233 coll OFF
T233 contact OFF
X5 OFF
ON
ON
9 seconds
RST T233
X7
T233 reset command
X7 OFF
ON
9 seconds
6 seconds
6 seconds
ON
1.5 seconds
1 seconds
T233 current value
~
0 1 90 91 100 0 1 60
~
~
Reset input
(d) When #6449 bit0=1, the value is set with a decimal (Kn), and can be designated from 1 to 32767
(0.1 to 3267.7 s). The data register (D) data can also be used as the setting value. File register (R)
cannot be used.
(e) When the bit selection parameter (#6449 bit2=1) is set, the 100ms integrated timer current value
(count value) will be held even when the power is turned OFF.
(2) With the device T, the contact • coil is handled as bit device, and the current value is handled as
word device. In the function commands described after, the word device T indicates the current
value even if there is no description about it.
(3) When #6449 bit0=0 is set, timer value can be specified with the parameter set in the setting and
display unit. At this time, the relationship between timer device and parameter is as shown below.
Device Parameter
T0 to T15
T56 to T135
T232 to T239
#6000 to #6015
#6016 to #6095
#6096 to #6103
(Note 1) T16 to T55, T136 to T231, and T240 to T255 are specified with a program (Kn) regardless of
#6449 bit0.
(Note2) Even when #6449 bit0=0, Kn is required for a sequence program. Note that, however, the Kn
value is invalid.
(Note 3) When the data register (D) is used as setting value, the data register (D) details will be the
setting value regardless of #6449 bit0.