Filter
Top Products
11. PLC Axis Control
- 284 -
11.3.3.2 Status
The status is set by the NC to indicate the execution status of this function command and the status of
the axis being controlled.
F E D C B A 9 876543210
R
n
+ 1
bit 0: busy Command processing bit 8 : oper Option error
1: den Axis movement completed 9 :
2: move Axis moving A:
3: SA Servo ready B:
4: svon Servo ON C:
5: ZP Reference point reached D:
6: E: ALM2 Axis in control alarm
7: F: ALM1 Control information data
designation alarm
bit 0: busy Command processing
This turns ON when the command is being processed.
The next command is not received while this bit is ON. The next command to be issued is
received while this bit is OFF.
bit 1: den Axis movement completed
This bit turns ON when the initialization and commanded movement are completed. This bit
stays OFF during movement, even when an interlock is applied. This bit turns ON at reset or
servo OFF, or when ACT = 0.
bit 2: move Axis moving
This bit turns ON when the machine is moving, and turns OFF when the machine is stopped.
bit 3: SA Servo ready
This bit turns ON when the servo is ready. It turns OFF during emergency stops and servo
alarms.
bit 4: svon Servo ON
This bit turns OFF when a servo OFF signal is output. It also turns OFF during emergency stops
and servo alarms.
Machine movement is possible when this signal is ON.
bit5: ZP Reference point reached
This bit turns ON when the reference point is reached after completion of a reference point
return.
It turns OFF when the machine moves.