Filter
Top Products
11. PLC Axis Control
- 294 -
11.3.3.5 Axis Designation
The axis No. of the PLC axis is designated.
R
n
+ 4
0: 1st axis
1: 2nd axis
11.3.3.6 Operation Mode
The operation mode for the PLC axis is designated.
For example, in the handle mode, Rn+5=6 (DATA) is set.
R
n
+ 5
0: Rapid traverse (G0)
1: Cutting feed (G1)
2: Jog feed (+)
3: Jog feed (-)
4: Reference point return (+)
5: Reference point return (-)
6: Handle feed
The axis movement will not be affected by changing the operation mode, even while the axis is
moving. The new operation mode is validated at the next start.
Axis designation
Operation mode