Filter
Top Products
Reference Manual
IP2030/RM, Rev AA
Section 4: Getting started
June 2014
Section 4: Getting started30
4.4 A quick tour of the menu system
Follow these instructions for a quick tour of the menu system:
1. This quick tour begins at the Full Display or Large PV Display (Figure 4-5 on page 31).
If already within the menu system, use the Esc button repeatedly until the Full Display
re-appears.
2. Press the red (ENTER) button to display the MAIN MENU (see Figure 4-5 on page 31).
The MAIN MENU is the top level of the menu system.
3. Navigation of the menu system is achieved by using the ARROW buttons,
the red (ENTER) button, and the Esc button.
The Esc button returns you to the previous menu level, unless you are at the top level.
4. The highlighted and blinking text indicates what menu option will be selected if the
red (ENTER) button was pressed now. Do not press it yet.
5. The
symbol on the display indicates there are further menu options available,
accessible by using the DOWN-ARROW button.
An
symbol indicates there are further menu options available, accessible by using the
UP-ARROW button.
6. The MAIN MENU sits above a series of sub-menus, which lead to further levels of
sub-menus that lead to parameter screens (see Figure 4-6 on page 31).
7. Press the red (ENTER) button to select the highlighted menu option SETUP.
8. The SELECT INSTRUMENT menu now appears. This screen is for selecting whether to
enter the setup menu for the control unit (controller) or a found HART transmitter.
If there are no HART transmitters connected, Step 7 results in the SETUP menu for the control
unit appearing straight away. Skip to Step 10.
9. Press the red (ENTER) button to select the highlighted menu option Controller: ****.
10. The control unit SETUP menu now appears with menu options APPLICATION, DISPLAY,
and OUTPUT visible.
11. Use the DOWN-ARROW button to highlight OUTPUT and then press the red (ENTER)
button to select and enter the OUTPUT menu.
12. The OUTPUT menu now appears with menu options CURRENT OUTPUT, RELAY,
TOTALIZER, PV DAMPING, ALARM, and FAULT.
13. Explore these menu options to see screens for setting-up for an application and for
displaying read-only information.
14. After exploring, hold down the Esc button once to return to the MAIN MENU.