Filter
Top Products
Reference Manual
IP2030/RM, Rev AA
Section 4: Getting started
June 2014
Section 4: Getting started102
4.5.26 Display configuration options
The factory default configuration of the full display can be changed to show different graphic
and text information.
Menu: SETUP / [CONTROLLER /] OUTPUT / DISPLAY
P570 Display Upper (Factory default is "P731-Time")
Select from the multiple-choice list of parameters (see Table 4-9 on page 103).
For example, a totalizer count can be displayed when D828-Totalizer is selected.
If it will fit, the clock time will also be displayed alongside the selected parameter
P571 Display Middle (Factory default is "D800-PV")
Select from the multiple-choice list of parameters (see Table 4-9 on page 103).
For example, the control unit Secondary Value (SV) value can be displayed when
D801-SV is selected
P572 Display Lower (Factory default is “Bar graph”)
Select from the multiple-choice list of parameters (see Table 4-9 on page 103). For
example, you can display a user-defined message (P241) when the 'P241' option is
selected
P573 Decimal places (Factory default is 3)
Use this to adjust the number of decimal places. Range 0 to 5. Alternatively, select
“Disabled” (Auto) for the control unit to automatically choose the number of decimal
places for a displayed parameter value
P574 Display size (Factory default is “Large”)
Use this to adjust whether the display shows the Large PV Display after a period of
keypad inactivity, or remains showing the Full PV Display.
P575 Back light (Factory default is "On")
Select from On (always on), Off (always off) or Auto (goes on when using keypad; goes
off after 5 minutes of inactivity)