Filter
Top Products
Reference Manual
IP2030/RM, Rev AA
Section 3: Installation
June 2014
Section 3: Installation12
Procedure
1. Unpack the two screw clips provided.
2. Identify the moulded lugs (protrusions) in the recesses on each side of the control unit.
(Ignore the recesses on the top and bottom of the unit).
3. Holding the screwdriver-slot-end of the threaded spindle of one of the screw clamps
and looking at the control unit rear, engage a screw clamp frame onto the control unit
side (see Figure 3-1 on page 12) and see how the four steel lugs (protrusions) of the
screw clamp frame engage with the moulded lugs of the unit. Gently pull the screw
clamp for the lugs to engage with each other.
4. Remove the screw clamps from both of the screw clamp frames.
5. Slide the control unit into the panel, ensuring that the panel seal provided is in place
behind the front panel bezel.
6. Re-fit the screw clamps, one on each side, and tighten with a screwdriver to clamp the
control unit against the panel.
7. For electrical connections,
see “Making electrical connections on panel-mount units” on page 15.
Figure 3-1. The fitted screw clamp
A. Screw Clamp Frame
B. Front Panel Bezel
C. Screw Clamp With Threaded Spindle
C
B
A