Filter
Top Products
724 CHAPTER 24: BOOT PROMPT COMMANDS
Usage — If you use an optional parameter, the parameter setting
overrides the setting of the same parameter in the currently active boot
profile. However, the boot profile itself is not changed. To display the
currently active boot profile, use the display command. To change the
currently active boot profile, use the change command.
Examples — The following command loads system image file
WXA30001.Rel from boot partition 1:
boot> boot FN=WXA03001.Rel DEV=boot1
Compact Flash load from boot0:WXA03001.Rel.
unzip: Inflating ramdisk_3.0.1_092304_WX4400 OK
unzip file len 36196930 OK
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004
The NetBSD Foundation, Inc. All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Detecting hardware...done.
readclock: 2004-9-29 21:45:7.31 UTC
system initialized (3.0.1), starting MSS
Executing update_3
Starting supervisor 3.0.1_092304_WX4400 ...
SNMPD Sep 29 21:45:34.262293 NOTICE SNMPD: SNMP Agent Resident Module Version
16.1.0.0
SNMPD Sep 29 21:45:34.263146 NOTICE SNMPD: Copyright (c) 2004 3Com Corporation.
All rights reserved.
SYS Sep 29 21:45:36.849457 NOTICE Port 1 up 1000 Full Duplex
SYSLOGD Sep 29 21:45:38.857125 ALERT SYSTEM_READY: The system has finished
booting. (cause was "Warm Reboot")
Copyright (c) 2004 3Com Corporation. All rights reserved.
Username:
See Also
change on page 725
display on page 730