Filter
Top Products
display config 675
Table 114 describes the fields in the display boot output.
See Also
display version on page 677
reset system on page 683
set boot configuration-file on page 687
display config Displays the configuration running on the WX.
Syntax —
display config [area area] [all]
area area — Configuration area. You can specify one of the
following:
aaa
acls
ap
arp
eapol
httpd
ip
Table 114 Output for display boot
Field Description
Configured boot
version
Software version the switch will run next time the software is
rebooted.
Configured boot
image
Boot partition and image filename MSS will use to boot next
time the software is rebooted.
Configured boot
configuration
Configuration filename MSS will use to boot next time the
software is rebooted.
Backup boot
configuration
The name of the configuration file to be used in the event
that MSS cannot read the configured boot configuration file
next time the software is rebooted.
Booted version Software version the switch is running.
Booted image Boot partition and image filename MSS used the last time
the software was rebooted. MSS is running this software
image.
Booted configuration Configuration filename MSS used to load the configuration
the last time the software was rebooted.