3Com WXR100 3CRWXR10095A Video Game Controller User Manual


 
344 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
History —Introduced in MSS Version 3.0. Version 6.0 removed the dap
option.
Usage — The serial-id parameter displays the active connection for the
specified Distributed MAP even if that MAP is not configured on this WX
switch. If you instead use the command with the dap-num parameter or
without a parameter, connection information is displayed only for
Distributed MAPs that are configured on this WX switch.
This command provides information only if the Distributed MAP is
configured on the switch where you use the command. The switch does
not need to be the one that booted the MAP, but it must have the MAP in
its configuration. Also, the switch that booted the MAP must be in the
same Mobility Domain as the switch where you use the command.
If a Distributed MAP is configured on this WX switch (or another WX switch
in the same Mobility Domain) but does not have an active connection, the
command does not display information for the MAP. To show connection
information for Distributed MAPs, use the display ap global command on
one of the switches where the MAPs are configured.
Examples — The following command displays information for all
Distributed MAPs configured on this WX switch that have active
connections:
WX1200# display ap connection
Total number of entries: 2
AP Serial Id AP IP Address WX IP Address
--- ----------- --------------- ---------------
2 M9DE48B012F00 10.10.2.27 10.3.8.111
4 M9DE48B123400 10.10.3.34 10.3.8.111
The following command displays connection information specifically for a
Distributed MAP with serial ID M9DE48B6EAD00:
WX1200# display ap connection serial-id M9DE48B6EAD00
Total number of entries: 1
DAP Serial Id DAP IP Address WX IP Address
--- ----------- --------------- ---------------
9 M9DE48B6EAD00 10.10.4.88 10.9.9.11
Table 65 describes the fields in this display.