3Com WXR100 3CRWXR10095A Video Game Controller User Manual


 
308 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
clear ap radio Disables a MAP radio and resets it to its factory default settings.
Syntax
clear ap ap-num } radio {1 | 2 | all}
ap ap-number — Index value that identifies the MAP on the WX.
radio 1 — Radio 1 of the MAP.
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
radio all — All radios on the MAP.
Defaults — The clear ap radio command resets the radio to the default
settings listed in Table 51 and in Table 72 on page 416.
Table 51 Radio-Specific Parameters
Parameter Default Value Description
antennatype For most MAP models, the
default is internal.
For MP-620, the default
for the 802.11b/g radio is
ANT-1360-OUT. The
default for the 802.11a
radio is ANT-5360 OUT.
The default for the
802.11b/g radio on model
AP3150 is ANT1060.
External antenna model
Note: This parameter is
configurable only on MAPs
that support external
antennas.
auto-tune max-power—highest
setting allowed for the
country of operation or
highest setting
supported on the
hardware, whichever is
lower
max-retransmissions
10 percent
min-client-rate5.5 Mb
ps for 802.11b/g;
24 Mbps for 802.11b/g
RF Auto-Tuning settings:
max-power—maximum
power that RF Auto-Tuning
can set on a radio
max-retransmissions—ma
ximum percentage of
client retransmissions a
radio can experience
before RF Auto-Tuning
considers changing the
channel on the radio
min-client-rate—minimum
rate at which a radio is
allowed to transmit traffic
to clients