Filter
Top Products
set radio-profile service-profile 425
cipher-ccmp disable Does not use Counter with Cipher Block
Chaining Message Authentication Code
Protocol (CCMP) to encrypt traffic sent to
WPA clients.
cipher-tkip enable When the WPA IE is enabled, uses
Temporal Key Integrity Protocol (TKIP) to
encrypt traffic sent to WPA clients.
cipher-wep104 disable Does not use Wired Equivalent Privacy
(WEP) with 104-bit keys to encrypt traffic
sent to WPA clients.
cipher-wep40 disable Does not use WEP with 40-bit keys to
encrypt traffic sent to WPA clients.
cos 0 If static CoS is enabled (static-cos is set to
enable), assigns CoS 0 to all data traffic
to or from clients.
dhcp-restrict disable Does not restrict a client’s traffic to only
DHCP traffic while the client is being
authenticated and authorized.
idle-client-probing enable Sends a keepalive packet (a null-data
frame) to each client every 10 seconds.
long-retry-count 5 Sends a long unicast frame up to five
times without acknowledgment.
no-broadcast disable Does not reduce wireless broadcast traffic
by sending unicasts to clients for ARP
requests, DHCP Offers, and Acks instead
of forwarding them as multicasts.
proxy-arp disable Does not reply on behalf of wireless
clients to ARP requests for client IP
addresses. Instead, the radio forwards the
ARP Requests as wireless broadcasts.
psk-phrase No passphrase
defined
Uses dynamically generated keys rather
than statically configured keys to
authenticate WPA clients.
psk-raw No preshared
key defined
Uses dynamically generated keys rather
than statically configured keys to
authenticate WPA clients.
rsn-ie disable Does not use the RSN IE in transmitted
frames.
Table 73 Defaults for Service Profile Parameters (continued)
Parameter Default Value
Radio Behavior When Parameter Set
to Default Value