Filter
Top Products
44 CHAPTER 3: SYSTEM SERVICE COMMANDS
clear system Clears the system configuration of the specified information.
CAUTION: If you change the IP address, any currently configured
Mobility Domain operations cease. You must reset the Mobility Domain.
Syntax —
clear system [contact | countrycode | idle-timeout
| ip-address | location | name]
contact — Resets the name of contact person for the WX switch to
null.
countrycode — Resets the country code for the WX switch to null.
idle-timeout — Resets the number of seconds a CLI management
session can remain idle to the default value (3600 seconds).
ip-address — Resets the IP address of the WX switch to null.
location — Resets the location of the WX switch to null.
name — Resets the name of the WX switch to the default system
name, which is the model number.
Defaults — None.
Access — Enabled.
History — —Introduced in MSS Version 3.0. Option idle-timeout added
in MSS Version 4.1.
Examples — To clear the location of the WX switch, type the following
command:
WX4400# clear system location
success: change accepted.
See Also
display config on page 675
display system on page 47
set system contact on page 60
set system countrycode on page 61
set system idle-timeout on page 65
set system idle-timeout on page 65
set system location on page 67