3Com WXR100 3CRWXR10095A Video Game Controller User Manual


 
166 CHAPTER 7: IP SERVICES COMMANDS
Examples — To display the offset from UTC, type the following
command:
WX4400# display timezone
Timezone set to 'pst', offset from UTC is -8 hours
See Also
clear summertime on page 145
clear timezone on page 146
display summertime on page 164
display timedate on page 165
set summertime on page 202
set timedate on page 204
set timezone on page 205
ping Tests IP connectivity between a WX and another device. MSS sends an
Internet Control Message Protocol (ICMP) echo packet to the specified
device and listens for a reply packet.
Syntax
ping host [count num-packets ] [dnf] [flood]
[interval time] [size size] [source-ip ip-addr | vlan-name]
host — IP address, MAC address, hostname, alias, or user to ping.
count num-packets — Number of ping packets to send. You can
specify from 0 through 2,147,483,647. If you enter 0, MSS pings
continuously until you interrupt the command.
dnf — Enables the Do Not Fragment bit in the ping packet to prevent
fragmenting the packet.
flood — Sends new ping packets as quickly as replies are received, or
100 times per second, whichever is greater.
Use the flood option sparingly. This option creates a lot of traffic and can
affect other traffic on the network.
interval time — Time interval between ping packets, in
milliseconds. You can specify from 100 through 10,000.
size size — Packet size, in bytes. You can specify from 56 through
65,507.