3Com WXR100 3CRWXR10095A Video Game Controller User Manual


 
336 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
Radio 1 type
Radio 2 type
(cont.)
The following information appears for external antennas:
External antenna detected, configured as
antenna-model—Indicates that an external antenna has
been detected, and lists the antenna model configured
on the radio. (MSS does not detect the specific model.)
External antenna detected, not configured—Indicates
that an external antenna was detected but no external
antenna is configured on the radio.
External antenna not detected, configured as
antenna-model—Indicates that an external antenna is
configured on the radio but no external antenna was
detected.
operational channel The channel on which the radio is currently operating.
If the channel number is followed by (Auto), the value was
set by RF Auto-Tuning.
operational power The power level at which the radio is currently operating.
If the power setting is followed by (Auto), the value was set
by RF Auto-Tuning.
base mac Base MAC address of the radio.
bssid, ssid SSIDs configured on the radio and their BSSIDs.
load balance Whether RF load balancing is enabled for the radio.
current load The load on this radio relative to the load balancing group
average or target load.
Table 60 Output for display ap status terse
Field Description
AP The number of the MAP connected.
Flag Operational status flags for the MAP.
For flag definitions, see the key in the command output.
Port WX port number connected to the MAP.
Flg Operational status flags for the MAP.
For flag definitions, see the key in the command output.
IP Address IP address of the MAP. The address is assigned to the MAP by
a DHCP server.
This field is applicable only if the MAP is configured on the
WX switch as a Distributed MAP.
Table 59 Output for display ap status (continued)
Field Description