Filter
Top Products
set ap boot-configuration mesh ssid 373
set ap
boot-configuration
mesh ssid
Specifies the name of the SSID a Mesh AP attempts to associate with
when it is booted.
Syntax —
set ap ap-number boot-configuration mesh ssid
mesh-ssid
ap ap-number — Index value that identifies the MAP on the WX.
mesh-ssid — Name of the mesh SSID (up to 32 characters).
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 6.0.
Usage — You must connect the MAP to a WX switch and enter this
command to
specify the mesh SSID prior to deploying the Mesh AP in its
final untethered location. When the MAP is booted its untethered
location, and it determines that it has no Ethernet link to the network, it
then associates with the specified mesh-ssid.
Note that when the mesh-ssid is specified, the regulatory domain of the
WX and the power restrictions are copied to the MAP flash memory. This
prevents the Mesh AP from operating outside of regulatory limits after it
is booted and before it receives its complete configuration from the WX.
Consequently, it is important that the regulatory and antenna information
specified on the WX actually reflects the locale where the Mesh AP is to
be deployed, in order to avoid regulatory violations.
Examples — The following command configures MAP 7 to attempt to
associate with
the SSID wlan-mesh when booted in an untethered
location:
WX# set ap 7 boot-configuration mesh ssid wlan-mesh
success: change accepted.
display ap mesh-links on page 329
set ap boot- configuration mesh mode on page 370
set service-profile mesh on page 450