Filter
Top Products
170 CHAPTER 7: IP SERVICES COMMANDS
set interface Configures an IP interface on a VLAN.
Syntax —
set interface vlan-id ip
{ip-addr mask | ip-addr/mask-length}
vlan-id — VLAN name or number.
ip-addr mask — IP address and subnet mask in dotted decimal
notation (for example, 10.10.10.10 255.255.255.0).
ip-addr/mask-length — IP address and subnet mask length in CIDR
format (for example, 10.10.10.10/24).
Defaults — None.
Access — Enabled.
History— Introduced in MSS Version 3.0.
Usage — You can assign one IP interface to each VLAN.
If an interface is already configured on the specified VLAN, this command
replaces the interface. If you replace an interface in use as the system IP
address, replacing the interface can interfere with system tasks that use
the system IP address, including the following:
Mobility domain operations
Topology reporting for dual-homed MAP access points
Default source IP address used in unsolicited communications such as
AAA accounting reports and SNMP traps
Examples — The following command configures IP interface
10.10.10.10/24 on VLAN default:
WX1200# set interface default ip 10.10.10.10/24
success: set ip address 10.10.10.10 netmask 255.255.255.0 on vlan default
The following command configures IP interface 10.10.20.10
255.255.255.0 on VLAN mauve:
WX1200# set interface mauve ip 10.10.20.10 255.255.255.0
success: set ip address 10.10.20.10 netmask 255.255.255.0 on vlan mauve