Filter
Top Products
clear spantree portpri 485
clear spantree
portpri
Resets to the default value the priority of a network port or ports for
selection as part of the path to the STP root bridge in all VLANs on a
wireless LAN switch or controller.
Syntax —
clear spantree portpri port-list
port-list — List of ports. The port priority is reset to 32 (the default)
on the specified ports.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command resets the priority in all VLANs. To reset the
priority for only specific VLANs, use the clear spantree portvlanpri
command.
Examples — The following command resets the STP priority on port 6 to
the default:
WX1200# clear spantree portpri 6
success: change accepted.
See Also
clear spantree portvlanpri on page 486
display spantree on page 488
set spantree portpri on page 507
set spantree portvlanpri on page 509
clear spantree
portvlancost
Resets to the default value the cost of a network port or ports on paths to
the STP root bridge for a specific VLAN on a wireless LAN switch, or for all
VLANs.
Syntax —
clear spantree portvlancost port-list {all | vlan
vlan-id}
port-list — List of ports. The port cost is reset on the specified
ports.
all — Resets the cost for all VLANs.