Filter
Top Products
200 CHAPTER 7: IP SERVICES COMMANDS
notify-only—The switch can use the string to send notifications.
read-write—An SNMP management application using the string
can get and set object values on the switch.
notify-read-write — An SNMP management application using
the string can get and set object values on the switch. The switch
can use the string to send notifications.
auth-type {none | md5 | sha} {auth-pass-phrase string |
auth-key hex-string}
— Specifies the authentication type used to
authenticate communications with the remote SNMP engine. You can
specify one of the following:
none—No authentication is used.
md5—Message-digest algorithm 5 is used.
sha—Secure Hashing Algorithm (SHA) is used.
If the authentication type is md5 or sha, you can specify a passphrase
or a hexadecimal key.
To specify a passphrase, use the auth-pass-phrase string option.
The string can be from 8 to 32 alphanumeric characters long, with
no spaces.
To specify a key, use the auth-key hex-string option.
encrypt-type {none | des | 3des | aes}
{encrypt-pass-phrase string | encrypt-key hex-string}
—
Specifies the encryption type used for SNMP traffic. You can specify
one of the following:
none—No encryption is used. This is the default.
des—Data Encryption Standard (DES) encryption is used.
3des—Triple DES encryption is used.
aes—Advanced Encryption Standard (AES) encryption is used.
If the encryption type is des, 3des, or aes, you can specify a
passphrase or a hexadecimal key.
To specify a passphrase, use the encrypt-pass-phrase string
option. The string can be from 8 to 32 alphanumeric characters
long, with no spaces.
To specify a key, use the encrypt-key hex-string option.