Filter
Top Products
388 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
Usage — You can configure the transmit power of a radio on the same
command line. Use the tx-power option.
This command is not valid if dynamic channel tuning (RF Auto-Tuning) is
enabled.
Examples — The following command configures the channel on the
802.11a radio on the MAP access point connected to port 5:
WX1200# set ap 5 radio 1 channel 36
success: change accepted.
The following command configures the channel and transmit power on
the 802.11b/g radio on the MAP access point connected to port 1:
WX1200# set ap 1 radio 1 channel 1 tx-power 10
success: change accepted.
See Also
display ap config on page 316
set ap radio tx-power on page 393
set ap radio
link-calibration
Configures an MAP radio to emit link calibration packets, which can aid
in positioning a Mesh AP.
Syntax — set ap ap-number radio {1 | 2} link-calibration mode
{enable | disable}
ap ap-number — Index value that indentifies the MAP on the WX.
radio 1 — Radio 1 of the MAP.
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
mode enable — Enables link calibration packets for the MAP radio.
mode disable — Disables link calibration packets for the MAP radio.
Defaults — Disabled.
Access — Enabled.
History — Introduced in MSS Version 6.0.