Filter
Top Products
198 CHAPTER 7: IP SERVICES COMMANDS
set snmp security Sets the minimum level of security MSS requires for SNMP message
exchanges.
Syntax —
set snmp security
{unsecured | authenticated | encrypted | auth-req-unsec-notify}
unsecured — SNMP message exchanges are not secure. This is the
only value supported for SNMPv1 and SNMPv2c.
authenticated — SNMP message exchanges are authenticated but
are not encrypted.
encrypted — SNMP message exchanges are authenticated and
encrypted.
auth-req-unsec-notify— SNMP message exchanges are
authenticated but are not encrypted, and notifications are neither
authenticated nor encrypted.
Defaults — By default, MSS allows nonsecure (unsecured) SNMP
message exchanges.
Access — Enabled.
History — Introduced in MSS Version 4.0.
Usage — SNMPv1 and SNMPv2c do not support authentication or
encryption. If you plan to use SNMPv1 or SNMPv2c, leave the minimum
level of SNMP security set to unsecured.
Examples — The following command sets the minimum level of SNMP
security allowed to authentication and encryption:
WX1200# set snmp security encrypted
success: change accepted.
See Also
set ip snmp server on page 180
set snmp community on page 185
set snmp notify target on page 192
set snmp notify profile on page 187
set snmp protocol on page 197