3Com WXR100 3CRWXR10095A Video Game Controller User Manual


 
404 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
Examples — The following command changes the channel holddown
for radios in radio profile rp2 to 600 seconds:
WX4400# set radio-profile rp2 auto-tune channel-holddown 600
success: change accepted.
See Also
display radio-profile on page 350
set radio-profile auto-tune channel-config on page 402
set radio-profile auto-tune channel-lockdown on page 405
set radio-profile
auto-tune
channel-interval
Sets the interval at which RF Auto-Tuning decides whether to change the
channels on radios in a radio profile. At the end of each interval, MSS
processes the results of the RF scans performed during the previous
interval, and changes radio channels if needed.
Syntax
set radio-profile name auto-tune channel-interval
seconds
name — Radio profile name.
seconds Number of seconds RF Auto-Tuning waits before changing
radio channels to adjust to RF changes, if needed. You can specify
from 0 to 65535 seconds.
Defaults — The default channel interval is 3600 seconds (one hour).
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — 3Com recommends that you use an interval of at least 300
seconds (5 minutes).
RF Auto-Tuning can change a radio’s channel before the channel interval
expires in response to RF anomalies. Even in this case, channel changes
cannot occur more frequently than the channel holddown interval.
If you set the interval to 0, RF Auto-Tuning does not reevaluate the
channel at regular intervals. However, RF Auto-Tuning can still change the
channel in response to RF anomalies.