Filter
Top Products
122 CHAPTER 5: VLAN COMMANDS
See Also
clear fdb on page 104
display fdb on page 109
set fdb agingtime Changes the aging timeout period for dynamic entries in the forwarding
database.
Syntax —
set fdb agingtime vlan-id age seconds
vlan-id — VLAN name or number. The timeout period change
applies only to entries that match the specified VLAN.
age seconds — Value for the timeout period, in seconds. You can
specify a value from 0 through 1,000,000. If you change the timeout
period to 0, aging is disabled.
Defaults — The aging timeout period is 300 seconds (5 minutes).
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the aging timeout period
to 600 seconds for entries that match VLAN orange:
WX4400# set fdb agingtime orange age 600
success: change accepted.
See Also
display fdb agingtime on page 111