3Com WXR100 3CRWXR10095A Video Game Controller User Manual


 
384 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
Defaults — All radios use the internal antenna by default, if the MAP
model has an internal antenna. The MP-620 802.11b/g radio uses model
ANT-1360-OUT by default. The MP-620 802.11a radio uses model
ANT-5360-OUT by default. The AP 3150 802.11b/g radio uses model
ANT1060 by default.)
Access — Enabled.
History — Introduced in MSS Version 3.0. Model numbers added for
802.11a external antennas, and the default changed to internal (except
for the AP3150) in MSS Version 3.2. Model numbers added for MP-620
external antennas.
Examples — The following command configures the 802.11b/g radio on
Distributed MAP 1 to use antenna model ANT1060:
WX4400# set ap 1 radio 1 antennatype ANT1060
success: change accepted.
See Also
display ap config on page 316
set ap radio
auto-tune
max-power
Sets the maximum power that RF Auto-Tuning can set on a radio.
Syntax set {ap ap-number auto} radio {1 | 2} auto-tune
max-power power-level
ap ap-number — Index value that identifies the MAP on the WX.
ap auto — Sets the maximum power for radios configured by the
MAP configuration profile. (See set ap auto on page 362.)
radio 1 Radio 1 of the MAP.
radio 2 Radio 2 of the MAP. (This option does not apply to
single-radio models.)
power-level — Maximum power setting RF Auto-Tuning can assign
to the radio, expressed as the number of decibels in relation to 1
milliwatt (dBm). You can specify a value from 1 up to the maximum
value allowed for the country of operation.
The power-level can be a value from 1 to 20.