Filter
Top Products
set snmp notify target 195
SNMPv2c with Traps To configure a notification target for traps from SNMPv2c, use the
following command:
Syntax —
set snmp notify target target-num ip-addr[:udp-port-number]
v2c community-string trap
[profile profile-name]
target-num — ID for the target. This ID is local to the WX switch and
does not need to correspond to a value on the target itself. You can
specify a number from 1 to 10.
ip-addr[:udp-port-number] — IP address of the server. You also
can specify the UDP port number to send notifications to.
community-string — Community string.
profile profile-name — Notification profile this SNMP user will use
to specify the notification types to send or drop.
SNMPv1 with Traps To configure a notification target for traps from SNMPv1, use the
following command:
Syntax —
set snmp notify target target-num ip-addr[:udp-port-number]
v1 community-string
[profile profile-name]
target-num — ID for the target. This ID is local to the WX switch and
does not need to correspond to a value on the target itself. You can
specify a number from 1 to 10.
ip-addr[:udp-port-number] — IP address of the server. You also
can specify the UDP port number to send notifications to.
community-string — Community string.
profile profile-name — Notification profile this SNMP user will use
to specify the notification types to send or drop.
Defaults — The default UDP port number on the target is 162. The
default minimum required security level is unsecured. The default
number of retries is 0 and the default timeout is 2 seconds.
Access — Enabled.
History — Introduced in MSS Version 4.0.