Filter
Top Products
292 CHAPTER 10: NETWORK DOMAIN COMMANDS
clear
network-domain
Clears all Network Domain configuration and information from a WX ,
regardless of whether the WX is a seed or a member of a Network
Domain.
Syntax —
clear network-domain
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Examples — This command has no effect if the WX is not configured as
part of a Network Domain.
To clear a Network Domain from a WX within the domain, type the
following command:
WX1200# clear network-domain
This will clear all network-domain configuration. Would you
like to continue? (y/n) [n] y
success: change accepted.
See Also
set network-domain mode member seed-ip on page 298
set network-domain peer on page 299
set network-domain mode seed domain-name on page 300
clear network-domain peer on page 294
clear network-domain seed-ip on page 295
display network-domain on page 296
Table 48 Network Domain Commands by Usage (continued)
Type Command