Filter
Top Products
298 CHAPTER 10: NETWORK DOMAIN COMMANDS
set
network-domain
mode member
seed-ip
Sets the IP address of a Network Domain seed. This command is used for
configuring a WX as a member of a Network Domain. You can specify
multiple Network Domain seeds and configure one as the primary seed.
Syntax —
set network-domain mode member seed-ip ip-addr
[affinity num]
ip-addr — IP address of the Network Domain seed, in dotted
decimal notation.
num — Preference for using the specified Network Domain seed. You
can specify a value from 1 through 10. A higher number indicates a
greater preference.
Defaults — The default affinity for a Network Domain seed is 5.
Access — Enabled.
History —Introduced in MSS 4.1.
Usage — You can specify multiple Network Domain seeds on the WX.
When the WX needs to connect to a Network Domain seed, it first
attempts to connect to the seed with the highest affinity. If that seed is
unavailable, the WX attempts to connect to the seed with the
next-highest affinity. After a connection is made to a non-highest-affinity
seed, the WX switch then periodically attempts to connect to the
highest-affinity seed.
Examples — The following command sets the WX switch as a member
of the Network Domain whose seed has the IP address 192.168.1.8:
WX1200# set network-domain mode member seed-ip 192.168.1.8
success: change accepted.
The following command sets the WX as a member of a Network Domain
whose seed has the IP address 192.168.9.254 and sets the affinity for
that seed to 7. If the WX specifies other Network Domain seeds, and they
are configured with the default affinity of 5, then 192.168.9.254
becomes the primary Network Domain seed for this WX.
WX1200# set network-domain mode member seed-ip 192.168.9.254
affinity 7
success: change accepted.