3Com WXR100 3CRWXR10095A Video Game Controller User Manual


 
590 CHAPTER 16: RADIUS AND SERVER GROUP COMMANDS
Do not use the same name for a RADIUS server and a RADIUS server
group.
Examples — To set server group shorebirds with members heron, egret,
and sandpiper, type the following command:
WX1200# set server group shorebirds members heron egret
sandpiper
success: change accepted.
See Also
clear server group on page 581
display aaa on page 229
set server group load-balance on page 590
set server group
load-balance
Enables or disables load balancing among the RADIUS servers in a server
group.
Syntax
set server group group-name load-balance
{enable | disable}
group-name Server group name of up to 32 characters.
load-balance enable | disable — Enables or disables load
balancing of authentication requests among the servers in the group.
Defaults — Load balancing is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You can optionally enable load balancing after assigning the
server group members. If you configure load balancing, MSS sends each
AAA request to a separate server, starting with the first one on the list
and skipping unresponsive servers. If no server in the group responds,
MSS moves to the next method configured with set authentication and
set accounting.
In contrast, if load balancing is not configured, MSS always begins with
the first server in the list and sends unfulfilled requests to each
subsequent server in the group before moving on to the next configured
AAA method.