396 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
Examples — The following command configures a WX to require
Distributed MAPs to have encryption keys:
WX4400# set ap security require
See Also
display ap config on page 316
display ap status on page 331
set ap fingerprint on page 376
set ap
upgrade-firmware
Disables or reenables automatic upgrade of a MAP access point boot
firmware.
Syntax —
set ap auto upgrade-firmware {enable | disable}
ap auto — Configures firmware upgrades for the MAP configuration
profile (See “set ap auto” on page 362.)
enable — Enables automatic firmware upgrades.
disable — Disables automatic firmware upgrades.
Defaults — Automatic firmware upgrades of MAP access points are
enabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option auto added for
configuration of the MAP configuration profile. Version 6.0 removed the
dap option.
Usage — When the feature is enabled on an WX port, a MAP access
point connected to that port upgrades its boot firmware to the latest
version stored on the WX switch.
Examples — The following command disables automatic firmware
upgrades on the MAP access point connected to port 6:
WX1200# set ap 6 upgrade-firmware disable
See Also
display ap config on page 316