3Com WXR100 3CRWXR10095A Video Game Controller User Manual


 
set radio-profile auto-tune power-ramp-interval 409
set radio-profile
auto-tune
power-ramp-interv
al
Changes the interval at which power is increased or decreased, in 1 dBm
increments, on radios in a radio profile until the optimum power level
calculated by RF Auto-Tuning is reached.
Syntax
set radio-profile name auto-tune
power-ramp-interval seconds
name—Radio profile name.
seconds—Number of seconds MSS waits before increasing or
decreasing radio power by another 1 dBm. You can specify from 1 to
65535.
Defaults — The default interval is 60 seconds.
Access — Enabled.
History —Introduced in MSS Version 5.0.
Examples — The following command changes the power ramp interval
for radios in radio profile rp2 to 120 seconds:
WX1200# set radio-profile rp2 auto-tune power-ramp-interval
120
success: change accepted.
See Also
set ap radio auto-tune max-power on page 384
set radio-profile auto-tune power-config on page 406
set radio-profile auto-tune power-interval on page 407
set radio-profile auto-tune power-ramp-interval on page 409
display radio-profile on page 350
set radio-profile
beacon-interval
Changes the rate at which each MAP radio in a radio profile advertises its
service set identifier (SSID).
Syntax
set radio-profile name beacon-interval interval
name — Radio profile name.
interval — Number of milliseconds (ms) between beacons. You can
specify from 25 ms to 8191 ms.
Defaults — The beacon interval for MAP radios is 100 ms by default.